خلاصة:
به منظور بررسی تاثیر آمالگام اتصال یافته با SBMPP و گلاس یونومر نوری، لاینر/بیس Vitrebond با روش رایج آمالگام و وارنیش، در افزایش مقاومت شکست دندانهای پیش مولر اول فک بالا با درمان ریشه، تحقیقی به روش تجربی بر روی 50 دندان سالم، به صورت in vitro در دانشکده دندانپزشکی، بخش ترمیمی دانشگاه علوم پزشکی شهید بهشتی در سال 1375 به عمل آمد. دندانها به صورت تصادفی به 5 گروه تقسیم شدند، بر روی 4 گروه، ابتد درمان ریشه انجام گردید، سپس حفره MOD بر روی آنها تراشیده شد. گروه اول دندان سالم، گروه دوم دندان تراش خورده بدون ترمیم، گروه سوم با وارنیش کوپالایت، گروه چهارم با SBMPP و گروه پنجم با گلاس یونومر نوری و آمالگام ترمیم شدند. دندانها به مدت 3 ماه در درجه حرارت 37 درجه سانتی گراد و تحت 2500 بار چرخه حرارتی بین 55-50 درجه سانتی گراد قرار گرفتند، مقاومت شکست دندانها با دستگاه Instron 8502 اندازه گیری شد. نتایج حاصل با آزمون آماری آنالیز واریانس و J-test بررسی گردید، حداکثر مقاومت شکست مربوط به دندانهای سالم و حداقل مربوط به دندانهای تراش خورده بدون ترمیم بود. در بین سه گروه دندانهای ترمیم شده، SBMPP بیشترین مقاومت شکست و گلاس یونومر نوری کمترین مقاومت شکست را داشتند. آنالیز واریانس اختلاف بین گروههای فوق را معنی دار نشان داد (P<0.001). بنابراین آمالگام اتصال یافته با SBMPP سبب افزایش مقاومت شکست دندان تراش خورده می گردد.
To determine the effectiveness of amalgam bonded with SBMPP and liner base light glass unomer (Vitrebond) compared to routine amalgam and varnish methods in increasing the break resistance of primary premolars of the upper jaw in root treatment, an in vitro experimental study was conducted on 50 healthy teeth in 1996. Each tooth was randomly assigned to one of five groups. In four groups, root treatment was performed first, followed by carving an MOD cavity. The first group consisted of normal teeth, the second were carved without repair, the third was repaired with copalite varnish, the fourth with SBMPP and the fifth with light glass unomer and amalgam. The teeth were kept at a temperature of 37 degrees centigrade and a pressure of 2500 bars for 3 months with a temperature cycle of 50-55 degrees. Tooth break resistance was measured with an Instron 8502. Results were analyzed by analysis of variance and the J-test. Maximum break resistance was observed in normal teeth and the minimum in teeth without repair. Of the three repaired groups, SBMPP showed the most break resistance and light glass unomer the least. Analysis of variance showed the differences of these groups to be significant (P<0.001). We therefore conclude that amalgam bound to SBMPP increases the break resistance of carved teeth.