چکیده:
فرسایش بادی وسعتی بالغبر 20 میلیون هکتار از کشور پهناور ایران را در متأثر ساخته است. هفت میلیون هکتار از مناطق تحت تأثیر فرسایش بادی کانونهای بحرانی نامیده میشود که کانونهای جمعیتی، اراضی کشاورزی و مناطق صنعتی را در برمیگیرد. فرسایشپذیری خاک از مهمترین شاخصهای نشاندهنده پتانسیل فرسایش بادی در یک منطقه است. این شاخص بستگی به ویژگیهای فیزیکی و شیمیایی ذاتی خاک دارد. منطقه موردمطالعه حوضه دشت یزد – اردکان که در بخش شمالی استان یزد قرار دارد و در فلات مرکزی ایران گسترده شده است. به منظور بررسی پتانسیل فرسایشپذیری بادی خشکهرودها و مجاور آنها 83 نمونه خاک در کف و بستر خشکه رودها و مجاور آنها در سه نوع دشتسر لخت، اپانداژ و پوشیده برداشته شد و برروی نمونهها به منظور محاسبه مقدار فرسایشپذیری آزمایشات فیزیکی و شیمیایی خاک صورت گرفت. مقدار فرسایشپذیری به دو روش دلگیلویچ و همکاران (1973)، مدل (1) و عظیمزاده و همکاران (1380)، مدل (2) بر حسب ton/ha-hr محاسبه شد. نتایج نشان داد که هر دو مدل در اراضی دشتسر پوشیده با بافت ریزدانه خاک از نوع Loam و Clay Loam مقدار فرسایشپذیری را متوسط تا زیاد پیشبینی کرد و در اراضی دشتسرهای لخت و اپانداژ که درصد پوشش سنگفرش متوسط تا زیاد میباشد، در مدل (1) مقدار فرسایشپذیری را در بعضی نقاط کم و در بعضی نقاط دیگر متوسط تا زیاد به دست آمد ولی در مدل (2) با در نظر گرفتن پوشش سنگفرش در تمامی نقاط دشتسرهای لخت و اپانداژ کم بدست آمد. مدل (1) بدون در نظر گرفتن رخسارههای مختلف ژئومورفولوژی، بیشتر در مورد بررسی میزان فرسایشپذیری بادی خاک در اراضی کشاورزی و دشت رسی با بافت ریزدانه خاک مناسب است و برآورد مقدار فرسایشپذیری را در قسمت میانی منطقه در مقایسه با مدل (2) بهدرستی پیشبینی کرد. بهمنظور سهولت و کاهش دادن زمان و هزینه بهمنظور محاسبه فرسایشپذیری، مدل (1) در اراضی بافت ریزدانه و کشاورزی و بدون سنگفرش شامل دشتسر پوشیده توصیه میشود. مدل (2) در دشتسرهای لخت و اپانداژ که دارای پوشش سنگفرش متوسط تا زیادی هستند، مدل مناسبی است و بهمنظور دقیقتر محاسبه فرسایشپذیری در دشتسر پوشیده علاوه بر پارامتر فیزیکی خاک، پارامترهای شیمیایی خاک هم که در عامل فرسایشپذیری دخالت دارند، مدل (2) مناسب میباشد. بهمنظور کاهش فرسایشپذیری در دشتسرهای لخت و اپانداژ باوجود درصد سنگفرش متوسط تا زیاد توصیه میشود هیچگونه دستکاری بر روی پوشش سنگفرش انجام نشود و در دشتسر پوشیده اقداماتی نظیر احداث بادشکن در اراضی کشاورزی و مالچ پاشی بر روی تپههای ماسهای انجام شود.
Introduction Wind erosion is a serious problem throughout the world. Wind erosion is due to the increase wind velocity and air turbulent. This phenomenon usually is seen in soft, smooth, bare, dry, disperse and fine soil. It always classifies to two main factors named erodibility and erosivity. The first depends on the physical and chemical properties of soil and the second depends on wind physic and kinetic energy. The aim of this study is estimating the potential soil wind erodibility in oueds and adjacent from them in coarse and medium grain plain and in fines and agricultural lands located in fine grain plain presented using two models. The first model based on percentage of particles larger than 0.84 millimeter in soils and the second model based on soil physical and chemical properties in study area. Methodology The case study is Yazd-Ardakan plain is located in north of Yazd province. Which is geographical location in the northern latitude 31 degrees 48 minutes and 32 degrees 13 minutes and eastern longitude 52 degrees 57 minutes and 54 degrees 59 minutes and has been widespread in the central plateau of Iran. In the case study, 83 soil samples were taken in 3 pediment including coarse grain plain, medium grain plain and fine grain plain in depth of 0-20 cm. Most of the samples were in oueds with high density and adjacent from them. some samples were in fines and agricultural lands in fine grain plain. To evaluate the potential soil wind erodibility in ton/ha-hr with Dolgelivich et al. method, it was calculated with percent of soil particle more than >0.84 millimeter and with Azimzadeh et.al.’s method, the potential soil wind erodibility was measured with physical and chemical soil parameters including: percent of pavement (reg), mean diameter (d50), Electrical Conductivity (EC), Sodium Absorb Ratio (SAR). Results and Discussion In 83 soil samples, the most soil texture was Sandy Loam which means that the area has the most percent of sand content. pavement was measured in range of 30 to 80 percent in coarse and medium grain plain and zero to 5 percent were variable in fine grain plain. The maximum amount of mean diameter was in range of 0.06 to 0.07 millimeter and the most percent of soil particle >0.84 millimeter was in range of 3.6 to 4. The amount of EC was variable from 1.5 to 6 dS/m and SAR was in range of 5.3 to 125.6 wich means soils in study area in terms of salinity were low to medium and in terms of alkali were medium to high. The amount of soil erodibility with model (1) was obtained in range of 30 to 36.98 ton/ha-hr and in model (2) was obtained in range of 0.04 to 80 ton/ha-hr. Both two models in fine grain plain with fine textured soil any kind of Loam and Clay Loam were estimated the amount of soil erodibility from medium to high and in coarse and medium grain plain lands which have medium to high desert pavement, in model (1) the amount of soil erodibility obtained low in some points and were high in the other points. But in model (2) with considering the percentage of desert pavement in all of the points in coarse and medium grain plain, the amount of soil erodibility obtained low. Model (1) without considering the geomorphological facies, is more useful and appropriate in agricultural and clayey plain lands and estimated properly the amount of soil erodibility in central of study area in comparison with model 2. In order to lower the time and cost to estimate the amount of soil erodibility in fine texture soils and agricultural lands located in fine grain plain, model (1) recommended. Model (2) is appropriate in coarse and medium grain plain which have medium to high desert pavement and in order to calculate more exactly the amount of soil erodibility in fine grain plain, in addition to soil physical parameters, soil chemical parameters that involve in soil erodibility factor, model (2) is appropriate. Conclusion Soil erodibility is an important issue in areas which were vulnerable to wind erosion. In clay and agricultural lands and some areas with sand dunes located in fine grain plain, we must have use some ways for lowering soil erodibility and controlling wind erosion for example making wind breaks surrounding agricultural lands and sprinkle mulch on sand dunes. In some areas which have low to high desert pavement, soil erodibility is low and any manipulation in the area is not recommended.
خلاصه ماشینی:
هدف تحقيق حاضر برآورد پتانسيل فرسايش پذيري بادي خاک در خشک رودها و مجاور آن ها در دشت سرهاي لخت ، اپانداژ و اراضي ريزدانه و کشاورزي واقع در دشت سر پوشيده با استفاده از دو مدل ارائه شده است .
(به تصویر صفحه مراجعه شود) شکل ٢:نقشه ژئومورفولوژي منطقه موردمطالعه براي محاسبه فرسايش پذيري بادي خاک برحسب تن در هکتار بر ساعت (ton/ha-hr) از روش دلگيلويچ و همکاران (١٩٧٣) تحت عنوان مدل (١) و عظيم زاده و همکاران (١٣٨٠) به عنوان مدل (٢) استفاده شد.
جدول ١:برآورد فرسايش پذيري بادي (دلگيلويچ و همکاران ، ١٩٧٣)، مدل (١) {مراجعه شود به فایل جدول الحاقی} در مدل (٢) براي نقاطي که در دشت سر لخت و اپانداژ قرار داشتند، از اطلاعات درصد سنگفرش و قطر ميانه آن ها استفاده شد ولي در نقاط واقع در دشت سر پوشيده ، علاوه بر پارامترهاي فيزيکي نظير بافت خاک از پارامترهاي شيميايي خاک ازجمله EC وSAR نيز مورد بررسي قرار گرفتند.
478ĝĝĝĝĝĝĝĝĝĝĝĝĝĝĝĝĝĝĝĝĝĝĝĝĝĝĝĝ (3) SG ــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــــ 1 Kitson and Mellon 2Ayers and Campbell در معادله (٣)، I: شاخص فرسايش پذيري بادي خاک برحسب kg/ha-hr در اراضي بياباني سنگفرشي، SG: درصد سنگريزه سطحي، d: ميانگين قطر ذرات خاک در لايه (٥-cm٠) با احتساب قطر سنگريزه سطحي سنگفرش است .
Australian Journal of Soil and Water Conservation, Vol. 7, No. 3, pp.
L. 2011: Soil erodibility dynamics and its representation for wind erosion and dust emission models, Aeolian Research, No. 3, pp.