Abstract:
در قسمت کوهستانی مشرف به شمال شرق شهر کرمان با کاربری مسکونی تفریحی، تحت تاثیر تکتونیزهی شدید، شاهد پرتگاه های گسلی و خطر ریزش سنگ در منطقه هستیم. در زمان ریزش، مشکل اصلی برای عناصر در معرض خطر، محل رسیدن قطعات سنگی است. بنابراین در نقشه های پهنهبندی حساسیت باید حساسیت مناطق نسبت به رسیدن قطعات را مد نظر گرفت و با بررسی و ارزیابی مسیر طی شده (Run-out) توسط ریزشها پهنه های با حساسیت زیاد، متوسط و کم تعیین گردد. بنابراین در ابتدا عوامل موثر در ایجاد ریزش شناسایی شد و سپس با دو روش ارزیابی چند معیاره ی مکانی (AHP) و روش آماری دو متغیره نسبت فراوانی، میزان اهمیت هرکدام از عوامل در منطقه تعیین و نقشهی پهنهبندی ریزشها بهمنزلهی غالبترین نوع حرکت دامنهای تهیه شد. بیشترین فراوانی ریزشهای منطقه در دامنه های گسلی، جهتهای شمال غرب و غرب و شیبهای ۱۵-۳۰ درجه دیده شدند. نقشهی حاصل از روش آماری دربرگیرندهی اکثریت پهنه های ریزشی و همچنین دربرگیرندهی مناطقی است که مسیر عبور ریزشها بودهاند، اما به دلیل دستکاری دامنه های منطقه برای تعیین آخرین محل رسیدن قطعات ریزشی، این نقشه نتوانست اطلاعات کامل را در اختیار بگذارد، بنابراین برای تکمیل نقشهی حساسیت منطقه از رابطه های تجربی زاویه ی رسیدن (Reach Angle) و زاویه ی سایه (Shadow Angle)، برای تخمین بیشترین فاصلهای که قطعات ریزشی ممکن است طی کنند استفاده گردید. در نقشهی نهایی، جاده های تفریحی حاشیهی دامنه در معرض خطر متوسط و مسیرهای کوهنوردی در معرض خطر زیاد شناسایی شدند.
Mountainous regions in the northeastern of Kerman with recreational-residential land use, face severe tectonic activities causing emersion of numerous faulty cliffs, leading to rock fall hazard. When rock fall happens, the main threat posed against exposed elements at risk is to what distance rock pieces will travel, therefore the susceptibility zoning must take into account the region susceptibility to this factor and then through evaluating the run-out of the falls, the zones should be classified into high, medium and low sensitivity. This study tries to prepare susceptibility map as stated earlier. The first step is to identify factors that causes rock fall events, then the importance of each factor in the region has to be determined by using AHP and bivariate statistical method, and finally zoning map of rock falls will be prepared as the most common type of hillside movements. The highest frequency of rock falls in the region have been seen on the faulty slopes, in the N-W and West directions and on 15-30 degrees slopes. The map created by bivariate statistical method contained most rock fall areas and also where rock falls had travels on them, however, due to the manipulation of the region, it is impossible to determine the last place that falling pieces had reached before; so the map does not provide full information. Thus for completing susceptibility map, empirical models such as Reach Angle and Shadow Angle approaches were used to estimate the maximum run-out distance that falling pieces may travel. Based on the final map, recreational roads are at average risk and climbing routes are at high risk.